1, according to the site environment and lighting needs, identifying where and how the installation of lighting will be the fixed installation, according to a 220V power supply contacts lamp distance, prepare the appropriate length of φ10 ~ 14mm cable. 
 2 Unscrew the lamp cover the upper part of the two fixed-wing bolts before opening the front cover, one end of the prepared cable into the device through the introduction of light compression nut cavity, according to the polarity marked connection seat, Firewire connection " L1 "side, the zero line then" N "terminal, ground receiving ground, then tighten the compression nut into the device. 
 3 Close the front cover and tighten the two wing bolt above, then the other end of the cable can be connected to 220V power lighting. 
 4, multiple lamp parallel, from the introduction of devices into the other cable wiring by the above method, and then connect with other lamps; single lamp to use when idle devices plug into the Frontier. 
 5, loosen the bracket screws on both sides can be adjusted within the range 15 ° up and down lighting angle. 
 6, the light inside the cavity with a supporting bar, turn on the light cover of the support may need to play.